Airsoft Canada - View Single Post

Syn · April 15th, 2008, 21:03

I did this for airpistol and I want to do it for my g36c using a cheap used flash hinder if i can find one.

Basicly my method: used a washer on the front and I cut an aluminum pipe, jb welded the washer onto the front.

The diameter of the hinder and the pipe are almost the same so I just used tape to fill in the gap and the pipe holds onto the hinder.

The aluminum pipe fro home depot 1" diameter 3feet was $10, wsher $0.87
I spray painted the fake "silencer" flat black.

Something stupid I did was use a hack saw to cut the pipe when my pipe cutter which was in my tool box a few feet away. d'oh

An improvement would be to find a more secure method of holding the pipe onto the hinder.

April 15th, 2008, 21:03	#2
Syn Trader rating Join Date: Aug 2005 Location: Toronto	I did this for airpistol and I want to do it for my g36c using a cheap used flash hinder if i can find one. Basicly my method: used a washer on the front and I cut an aluminum pipe, jb welded the washer onto the front. The diameter of the hinder and the pipe are almost the same so I just used tape to fill in the gap and the pipe holds onto the hinder. The aluminum pipe fro home depot 1" diameter 3feet was $10, wsher $0.87 I spray painted the fake "silencer" flat black. Something stupid I did was use a hack saw to cut the pipe when my pipe cutter which was in my tool box a few feet away. d'oh An improvement would be to find a more secure method of holding the pipe onto the hinder. __________________ Last edited by Syn; April 15th, 2008 at 21:09..