Airsoft Canada - View Single Post

TokyoSeven · June 5th, 2008, 22:16

It should just be a matter of running the wires out the back of the reciever.
Hopefully you have the correct G&P reciever as there are two types an A and a B, one is for front wire one is for rear wire. If there is no space to run the wires, a little work with a dremel can fix that.

If you do have the correct reciever running the wires is as easy as snaking them out the back and along the bottom of the recievers tube (or inside if there is a notch to do so) and then sliding the stock tube on.

If you dont, its a fairly simple operation with a dremel to make the neccesary spacing to put wires out the back.

June 5th, 2008, 22:16	#2
TokyoSeven Red Wine & Adderall Trader rating Join Date: Oct 2005 Location: Saskatoon, SK	It should just be a matter of running the wires out the back of the reciever. Hopefully you have the correct G&P reciever as there are two types an A and a B, one is for front wire one is for rear wire. If there is no space to run the wires, a little work with a dremel can fix that. If you do have the correct reciever running the wires is as easy as snaking them out the back and along the bottom of the recievers tube (or inside if there is a notch to do so) and then sliding the stock tube on. If you dont, its a fairly simple operation with a dremel to make the neccesary spacing to put wires out the back. __________________ "Its only a little bit on fire"