|
The hole doesnt have to line up. Just run the wires underneeth through that hole! and it will be a little bit of a push but you should be able to slide the buffer tube over the wiring after and reciever tube afterwards. If the wiring is fat you may shave off some of the plastic insulation when doing so, however I would think the King arms buffer tube would have a little extra space inside for that, or atleast the G&P body should be a little flatter on the bottom of the reciever tube to make room for the wires. Its perfectly fine if the wires dont go into the tube through the back right off the start.
__________________
"Its only a little bit on fire"
|