Quote:
Originally Posted by Muffin
Not sure what access you would have to tools, but if you even just have a hack saw you could trim the grip to the same length as the launcher. However, the whole front end sits really low, just curious if that may be too low to hold comfortably.
|
Yea i was thinking hacksaw would be the best best after carefully working it out.... Only have one grip lol. The main thing with this is trying not to muck anything up because it will cost more lol.
The grip on there is just resting in pics 2 and 3, so it will fit over the launcher when its done. In picture 1 it shows the grip a little high hence the red arrow would be ideally where it would be situated. It's fairly low down but it's actually really comfy. As its a support gun thats going to weigh a lot i think it will still have a sling on it and so its not going to be a gun brought up to eye level that offen. Imagine holding a gun around the waitline.
Started to do some work to the grip and Mini Launcher. Removing some of the Grenade launchers mechanism and trimming back the grip.
