Quote:
Originally Posted by HaZarD SFD
Grimm I would suggest some metal bushings, shimms, to properly shimm the mechbox.. Also you can just buy a 400+ MM barrel and its less cutting and less cost imho. If you have the MP5 SD you can get a barrel that will basically go just too the end of the silencer.
Everything else looks good. The modify head is a great add on.. I have one in my ICS and its taken alot of abuse. I would however suggest a guarder clear rubber instead of that hard type.. Those are mainly made if my thoughts are correct for 400+ AEG's.
Your accuracy will tighten a bit with the 6.03 but range you might get a bit further..
|
I have installed metal bushings and re-shimmed the mechbox. I'll also need to re-grease it since the last time I was in there it was looking a little dry. About the hard type bucking...I was thinking with the other upgrades, I'd end up around 400 fps? Right now it's shooting about 330 fps. The compression could be better; hence the piston head and nozzle. The stiffer spring, better compression, and tight bore I thought would bring me up to 400 fps?
Quote:
Originally Posted by Jugglez
Don't cut down Mad Bull barrels, they're teflon coated and it'll likely get damaged.
There is a 363mm length available and it's not far off from your desired length.
|
I'll go with that one then.