Quote:
Originally Posted by Marriott
Sorry on the wires.... They were there for testing some of the electronics. Yea there will be a full body created (hopefully for it) which is why i went with a gunbase with a lot of RIS. Yes there will also be a section built around the grenade launcher. I think i need to lower that down using Scope 20mm Weaver rail Base's, i may alsoadd a full gun length upper rail sustem to add the section above the Flash Hider.
There's alot of work to do still.
Well... The AGM HK416 base had a mini Tamiya connector on he end. My mp5k also uses a stick battery so i just borrowed it to connect up for testing. I still have to decide on Li-po, or 12V Ni-Mh battery pack so i'm using this for now.
Also.... The G&P stock inner design is better than the CA one i have but the CA one is far superior.... Stronger/Metal Buttplate not plastic, Far better battery compartment opening.... To be honest this G&P is turd in comparison... Just the fact that there was less inside to make fitting 12v easier made me choose it.
The one good thing with this project is i get to test out and try alot of parts  |
Take your CA Butt stock end and put it on the G&P one. That's what I did
