Airsoft Canada - View Single Post - G36 Hop-Up problems

Turd · September 7th, 2008, 03:41

Ok so last time i went out bb's were spitting out about 10 feet out of my barrel, at first i thought it was some sort of air seal issue but after taking apart my G36 ive noticed a bb quite harshly lodged in the hop-up. any thoughts or suggestions as to what has happened? also, when looking at the side of the cylinder, if i can see into it from the side to the other that would imply the spring is compressed? if so im assuming thats bad lol.

UPDATE: Well after taking a closer inspection i realized that the whole inner barrel is full of bb's, there has been a G36K outer barrel kit installed (that is actually too big for the threads on the gun) so ill take that off and see if that changes things

September 7th, 2008, 03:41	#1
Turd Liberal Assassin Trader rating Join Date: Jan 2008 Location: Alberta	G36 Hop-Up problems Ok so last time i went out bb's were spitting out about 10 feet out of my barrel, at first i thought it was some sort of air seal issue but after taking apart my G36 ive noticed a bb quite harshly lodged in the hop-up. any thoughts or suggestions as to what has happened? also, when looking at the side of the cylinder, if i can see into it from the side to the other that would imply the spring is compressed? if so im assuming thats bad lol. UPDATE: Well after taking a closer inspection i realized that the whole inner barrel is full of bb's, there has been a G36K outer barrel kit installed (that is actually too big for the threads on the gun) so ill take that off and see if that changes things __________________ CTW MK12 Mod 1 KWA HK45, USP 45 KSC G19 Last edited by Turd; September 7th, 2008 at 04:12..