Airsoft Canada - View Single Post

Muffin · September 14th, 2008, 16:33

So yesterday during a skirmish my teammates CA AUG went on the fritz. I've worked on virtually all of my teammates guns, but I can't seem to notice the problem with this one.
At the beginning of the game, it worked just fine, but halfway through a full auto burst, it began to skip. The pistons tension was fully released, the anti reversal intact, yet it could not pull back the piston. I knocked it out of the stock, and tried again(as you can visually see a bit of the sector gear). Upon pulling the trigger, it sounded as if the pinion gear was slipping/skipping on the bevel gear, as the sector gear was not rotating, but simply skaking back and forth.
I took it home after the game and opened it up and everything is as it should be, no missing teeth on any gears, motor and pinion seem fine, motor height adjustment was good.
Any ideas?

September 14th, 2008, 16:33	#1
Muffin Trader rating Join Date: Sep 2007 Location: Manitoba	CA AUG So yesterday during a skirmish my teammates CA AUG went on the fritz. I've worked on virtually all of my teammates guns, but I can't seem to notice the problem with this one. At the beginning of the game, it worked just fine, but halfway through a full auto burst, it began to skip. The pistons tension was fully released, the anti reversal intact, yet it could not pull back the piston. I knocked it out of the stock, and tried again(as you can visually see a bit of the sector gear). Upon pulling the trigger, it sounded as if the pinion gear was slipping/skipping on the bevel gear, as the sector gear was not rotating, but simply skaking back and forth. I took it home after the game and opened it up and everything is as it should be, no missing teeth on any gears, motor and pinion seem fine, motor height adjustment was good. Any ideas?