I've decided to explain my issue with pictures to make it clear. I'm using a Version 3 KA Reinforced Mechbox Shell for this.
First picture: All three pieces (labeled
1,
2,
3) are lined up properly, and safety works, will not fire.
Second Picture: selector switch transitions smoothly to semi, no problem, weapon fires on semi.
Third Picture: Suddenly... WTF? Things won't line up properly. The teeth of parts
1 and
2 line up just fine, but will not seat with the nub on part
3.
Fourth Picture: Try and fix it the other way... part
2 and
3 line up, and then suddenly the teeth will not! The red squared portion shows where the squared "tooth" on part
1 refuse to integrate with the teeth on part
2.
I am aware of the slightly damaged teeth on part
2. The issue isn't that the teeth won't grip each other... its that part
2 will not seat properly when the slide is in the fully auto position.
I feel like there is something obvious I'm missing here... the gun fired on full auto fine last time it was gamed. I dont do my own mechbox internals work, so my overall knowledge is only basic.
Anyone see an obvious error?... and please... be gentle.