Airsoft Canada - View Single Post

mcguyver · November 21st, 2008, 20:46

I don't pull the shims on the shaft, as you'd need to install the bearing and start using the height adjustment screw. Not everyone still has the bearing, and I can't supply them at the moment.

I solder the comm/pole junction, true the comm (and remove any arc damage) and install new brushes. They do run a bit quieter, but the 490 at it's best is louder than a 480, as it has more windings, more torque and turns a little faster.

November 21st, 2008, 20:46	#4
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	I don't pull the shims on the shaft, as you'd need to install the bearing and start using the height adjustment screw. Not everyone still has the bearing, and I can't supply them at the moment. I solder the comm/pole junction, true the comm (and remove any arc damage) and install new brushes. They do run a bit quieter, but the 490 at it's best is louder than a 480, as it has more windings, more torque and turns a little faster. __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy.