This thread is best left for WA users ONLY.
Specs:
WA Infinity Magna 6" Hicapa
- No upgrades (2nd Owner)
- Stock Plastic Slide
- Infinity Dual Tone Metal Slide
Problem 1: WA Hi-Cap Hard Impact Gas Route Rubber not staying in place
Rubber piece Picture
It appears that after a few shots the rubber piece gets dislodged upwards as the gas shoots straight up from the mag. Perhaps the rubber piece has seen its end of life as it feels very soft.
What I tried
*Lubing it (Did not Work)
*Tightening the screw near the exit valve (Helped)
It helped a little bit by increasing more of my shots before the gas just expels outwards
Possible Solutions
Correct me if I am wrong but it may just be the rubber piece that needs to be replaced?
I already have some rubber pieces on the way
************************************************** *
Problem 2: Not feeding properly
For some odd reason the BB's shoot out every other shot.
Example:
Load magazine in cock slide, shoot 1st time BB goes out 2nd shot does not, 3rd does, 4th does not, 5th does
What I tried
*
Use Stock Plastic Slide
Helped the cycling a lot better but get the occasional blank fire
Possible Solutions
Fellow airsofter achanamm says to replace recoil spring, I am getting a new one right now but need confirmation and further inquiry to be able to fully isolate this problem.