[Blackthorne]

I was looking at that option.

At this point I may have to disagree on the gear timing thing.

The bevel gear has more tightly spaced backstops than a standard gear. I can adjust the position of the gear relative to the other gears so that when the anti-reversal latch is engaged, the tappet is in the proper position. If I move it a couple of teeth forward so that the next anti-reversal stop is engaged, the tappet plate is it then engaged b the pin on the sector gear and is pulled back, putting the nozzle in the "half-way" position.

This of course only has any impact if the nozzle is truly irrelevant in the process of holding BB's in place.