Ok, my idea of a supressor is to have an inner sheath, which the BB will travel thru with many holes drilled into it, then some type of foam filling (most likely fbr) then an outer sheath to hold the foam in place.
Is my understanding of an airsoft supressor correct? I know it wont completely silence the gun because of the mechanical sounds, but the gas escaping is still pretty loud. It is a Propane NBB btw.
~Should the inner sheath be close to the diameter of the BB i.e 7mm?
~Or should it be much larger than the diameter of the BB i.e 16mm?
~Should there be a lot of room for the foam filling?
~Should platic or metal be used for the inner sheath?
~Should platic or metal be used for the outer sheath?
~Should the outer sheath be thick or thin?
~Should the inner sheath be thick or thin?
Thanks in advance, I know I ask a lot of questions
