[Rotting]

This is the only hop-up I could purchase that was full metal that fits inside the SiG552, basically they're interchangable. Problem now is that on a TM SiG552 Hop-Up, it has an additional little spot for a screw to go into, holding the metal plate in the mag-well against it, and then thus holding the hop-up perfectly still. The metal G3 hop-up is the same in every way, except for that little spot to screw the mag-well plate to it.

Is there any way to actually get that plate to stay in there? Since right now it kind of falls out of place. The metal plate doesn't fall out, though, since it is still connected in the body itself.



Also, just a side-note. I have a high-cap magazine, but I don't really like high-cap magazines. Neither does the rest of my team, so I was wondering if it's possible modify a high-cap magazine into a mid/low-cap magazine instead.



Thanks!