Airsoft Canada - View Single Post

prepaidpwnage · May 3rd, 2009, 20:27

Thanks for quick and helpful responses

*edit Ok, ill leave the4 barrel/ hop up alone. thanks for the advice *end edit*
The reason i was gonna save the deans till stage two is so that i wont install them and wire my gun to the rear and then have to take it all apart later to put the trigger master in.

so if i order from two stores I'd be looking at this:
-Modify Smooth gears
-Modify PolyCarbonate Piston(full teeth)
-modify polycarbonate reinforced piston head
-Modify Spring(not sure what strength to get)

May 3rd, 2009, 20:27	#4
prepaidpwnage Trader rating Join Date: Jan 2009 Location: New Jersey, USA	Thanks for quick and helpful responses edit Ok, ill leave the4 barrel/ hop up alone. thanks for the advice end edit* The reason i was gonna save the deans till stage two is so that i wont install them and wire my gun to the rear and then have to take it all apart later to put the trigger master in. so if i order from two stores I'd be looking at this: -Modify Smooth gears -Modify PolyCarbonate Piston(full teeth) -modify polycarbonate reinforced piston head -Modify Spring(not sure what strength to get) Last edited by prepaidpwnage; May 3rd, 2009 at 20:29..