Airsoft Canada - View Single Post - Introduction Thread: Post your hello's here not somewhere else.

J_K_S · January 29th, 2021, 21:49

Hi,

I?m Jerad, a red seal journeyman carpenter and locksmith from Wpg. I have never played Airsoft, but I was big into paintball in the early 2000s...(yes, I?m that old)

Here?s the thing, My hobby is 3D printing and I started making custom valve seals , gaskets and o-rings out of NinjaFlex TPU for vintage Crosman 38 pellet guns on EBay.

I was told to reach out to the Airsoft community, because you?d appreciate my talents more than the pellet pistol crowd. So.....

If youR good with a set of calipers, and need custom valves or seals printed from NinjaTek , or if you need certain Hard to find mags re-sealed, I?m your guy.

Cheers,
Jerad

January 29th, 2021, 21:49	#1572
J_K_S Trader rating Join Date: Jan 2021	3d printer go brrrr... Hi, I?m Jerad, a red seal journeyman carpenter and locksmith from Wpg. I have never played Airsoft, but I was big into paintball in the early 2000s...(yes, I?m that old) Here?s the thing, My hobby is 3D printing and I started making custom valve seals , gaskets and o-rings out of NinjaFlex TPU for vintage Crosman 38 pellet guns on EBay. I was told to reach out to the Airsoft community, because you?d appreciate my talents more than the pellet pistol crowd. So..... If youR good with a set of calipers, and need custom valves or seals printed from NinjaTek , or if you need certain Hard to find mags re-sealed, I?m your guy. Cheers, Jerad