Well, she's arrived and I got all my mags and cylinders ready to go.
Only one problem, that upper receiver is on so tight, my thumbs are turning blue trying so hard.
Is there a trick to separating the two parts so I may swap cylinders.
The instructions say ball bearing securing the upper receiver and considerable force is required.
I've pulled the pin out as much as it will go, a click is heard.
Thanks in advance.
DISREGARD, I ate some spinach and that did the job.
__________________
M16A3 MAX PTW,
TM G17,
6" straw
"Doubt all before you believe anything."
Sir Francis Bacon
Last edited by Trader 762; February 26th, 2008 at 14:15..
|