Magpul ACS STOCK REVIEW 56k death

spartan117 · October 17th, 2009, 00:42

Magpul ACS stock Review

I finally received my Magpul ACS stock otherwise known as the Adaptable Carbine Stock. The stock comes in three different colours: Dark Earth, Black, and OD.

Upon ripping off the package, a dented and creased box stood before me. Frantically i opened it to find not only no padding, or any sort of bubble wrap but a completely solid and clean looking stock. The weight of the stock is heavier than the ctr but not as heavy as the UBR.

The package included the stock, a small installation tool, and a manual for proper installation.

The ACS differs from the UBR and CTR in many different ways. Like the UBR the ACS has a small compartment on the right side however it is not interchangable. The stock also sports a friction lock and to make up for the one sided compartment, it includes two removable rubber tabs, located on either side, which reveals a small cylinder shaped compartment that is capable of storing a couple AA batteries. As shown in the picture below

In terms of comfort, the ACS is, in my opinion, much more comfortable compared to the CTR because of the angle cheek rest and unlike the UBR the ACS is a one piece design(obviously) which also adds to the comfort factor.

As you have seen in the first photo, the ACS sports the typical rubber buttstock pad just like its other brothers. In the picture below i have installed the Advanced rubber butt plate.

Upon installing the ACS stock onto my JG hk416, i found that the diameter for the buffer tube was a 1mm wider which pretty much disabled the friction lock function. But then again it is not needed because there is absolutely no wobble. However, with a little force the stock was successfully installed. I will later install this onto my AGM m4.

If you are looking for a stock that serves as a storage compartment and has great comfort the ACS stock is definitely for you. Out of all the stocks from Magpul i would highly recommend this stock to any airsoft player. This is trully the best stock i have ever owned. Worth my $100.

Hopefully you'll find this review informative enough to provide you enough encouragement to go and purchase one of these stocks for yourself. I apologize if the format is not good since this is one of my first detailed reviews. Thanks for reading!

scurvythepirate · October 17th, 2009, 00:58

Good review.

drew2r · October 17th, 2009, 00:59

very informative, I have been debating on what kind of stock I am going to get for my M4 I may rewire my gun to the front so I can get me one of these bad boys.

808 · October 17th, 2009, 11:27

Great review - good job for one of your first. Good info to have.

Too bad the stock is ugly!

CTR all the way!

MoreToasties · October 17th, 2009, 11:31

Informative, thank you. =)

spartan117 · October 17th, 2009, 14:03

Quote:

Originally Posted by 808

Great review - good job for one of your first. Good info to have.

Too bad the stock is ugly!

CTR all the way!

WHAT! Come on??!! lol I like it alot. lol

Ayashifx55 · October 26th, 2009, 18:47

what's for the AA battery for? Im just curious

o2slick · October 26th, 2009, 19:57

i think it is basically a place to put spare battery for aimpoint or other stuff

teck · April 12th, 2010, 23:17

Can you install a lipo in the buffer tube while stock is on?

dutchydoc · April 12th, 2010, 23:28

Quote:

Originally Posted by teck

Can you install a lipo in the buffer tube while stock is on?

If you had a LIPO in the buffer tube previous to installing the stock, there should not be a difference.

P.S.
Good information and quality pictures...good job on the review!

teck · April 12th, 2010, 23:30

Ya, but can you take off the butt plate to remove/install a lipo?

spartan117 · April 12th, 2010, 23:46

Quote:

Originally Posted by teck

Ya, but can you take off the butt plate to remove/install a lipo?

Here's a tip. The ACS stock itself is already pretty long so i never use it at the longest position. I usually use position 2 or 3 depending on the thickness of vest. So i'm planning on just drilling the small portion at the end of the buffer tube so it'll just slide all the way out and still have the 5th position. No need to use tools and such. I'll take pics when i dremel it out.

kbeckerton · January 28th, 2012, 15:35

Can you Put a 9.6 nunchuck battery in the cheek rests? i just ordered this stock and a new battery so i hope i can lol..

AngelusNex · January 28th, 2012, 15:43

Quote:

Originally Posted by kbeckerton

Can you Put a 9.6 nunchuck battery in the cheek rests? i just ordered this stock and a new battery so i hope i can lol..

it's not designed for that. The battery compartments on this stock are for spare batteries and are fully sealed.

To use it as a battery stock you'd need to do a fair bit of dremeling.

kbeckerton · January 28th, 2012, 16:24

ah ook, well hopefully i dont screw it up lol

Home	Forums	Register	Gallery	FAQ	Calendar
Retailers	Community	News/Info	International Retailers	IRC	Today's Posts

British Columbia	Alberta
BCAC	EAR
Op-For	JOC
Northern Arms Airsoft	Skunkworx Airsoft
Airsoft Kelowna	RAAT
Prince George Airsoft	Manitoba
Saskatchewan	MAA
SK Airsoft	Ontario
PDW	Airsoft Ottawa
South Sask Mercs	Snow Dragons
Quebec	1st Ranger Platoon
PQAC	Wolfpack Tactical
1st Pathfinders Regiment	TTAC3
Quebec Airsoft
MTX Airsoft	Atlantic
FAQc	Atlantic Airsoft

October 17th, 2009, 00:42	#1
spartan117 Trader rating Join Date: Sep 2007 Location: Vancouver B.C	Magpul ACS STOCK REVIEW 56k death Magpul ACS stock Review I finally received my Magpul ACS stock otherwise known as the Adaptable Carbine Stock. The stock comes in three different colours: Dark Earth, Black, and OD. Upon ripping off the package, a dented and creased box stood before me. Frantically i opened it to find not only no padding, or any sort of bubble wrap but a completely solid and clean looking stock. The weight of the stock is heavier than the ctr but not as heavy as the UBR. The package included the stock, a small installation tool, and a manual for proper installation. The ACS differs from the UBR and CTR in many different ways. Like the UBR the ACS has a small compartment on the right side however it is not interchangable. The stock also sports a friction lock and to make up for the one sided compartment, it includes two removable rubber tabs, located on either side, which reveals a small cylinder shaped compartment that is capable of storing a couple AA batteries. As shown in the picture below In terms of comfort, the ACS is, in my opinion, much more comfortable compared to the CTR because of the angle cheek rest and unlike the UBR the ACS is a one piece design(obviously) which also adds to the comfort factor. As you have seen in the first photo, the ACS sports the typical rubber buttstock pad just like its other brothers. In the picture below i have installed the Advanced rubber butt plate. Upon installing the ACS stock onto my JG hk416, i found that the diameter for the buffer tube was a 1mm wider which pretty much disabled the friction lock function. But then again it is not needed because there is absolutely no wobble. However, with a little force the stock was successfully installed. I will later install this onto my AGM m4. If you are looking for a stock that serves as a storage compartment and has great comfort the ACS stock is definitely for you. Out of all the stocks from Magpul i would highly recommend this stock to any airsoft player. This is trully the best stock i have ever owned. Worth my $100. Hopefully you'll find this review informative enough to provide you enough encouragement to go and purchase one of these stocks for yourself. I apologize if the format is not good since this is one of my first detailed reviews. Thanks for reading! Last edited by spartan117; October 17th, 2009 at 14:11..

October 17th, 2009, 00:58	#2
scurvythepirate Trader rating Join Date: Nov 2007 Location: Kelowna,BC	Good review. __________________

October 17th, 2009, 11:27	#4
808 Trader rating Join Date: Mar 2005 Location: 6mm-mag.com - Winnipeg	Great review - good job for one of your first. Good info to have. Too bad the stock is ugly! CTR all the way! __________________

October 17th, 2009, 00:59	#3
drew2r Trader rating Join Date: Mar 2007 Location: Windsor/Toronto, ON	very informative, I have been debating on what kind of stock I am going to get for my M4 I may rewire my gun to the front so I can get me one of these bad boys.

October 17th, 2009, 11:31	#5
MoreToasties Art affectionado Trader rating Join Date: Aug 2009 Location: North York, Ontario	Informative, thank you. =) __________________ God is a /b/tard.

October 26th, 2009, 18:47	#7
Ayashifx55 Trader rating Join Date: Jan 2008 Location: Quebec, Montreal	what's for the AA battery for? Im just curious

October 26th, 2009, 19:57	#8
o2slick Trader rating Join Date: Jul 2009 Location: Montreal	i think it is basically a place to put spare battery for aimpoint or other stuff __________________ Mb05,Glock 32c,G&G Gr16,G&G Mp5sd5,Ca m24

April 12th, 2010, 23:17	#9
teck Trader rating Join Date: Sep 2009 Location: Penticton,B.C	Can you install a lipo in the buffer tube while stock is on? __________________ PERKS: -One shot, one kill -Pack rat -Tourette syndrome sufferer -Phone addict -Tunnel rat -Sculptor -Chairsofter -I Mean Business -Quadruple Bypass

April 12th, 2010, 23:30	#11
teck Trader rating Join Date: Sep 2009 Location: Penticton,B.C	Ya, but can you take off the butt plate to remove/install a lipo? __________________ PERKS: -One shot, one kill -Pack rat -Tourette syndrome sufferer -Phone addict -Tunnel rat -Sculptor -Chairsofter -I Mean Business -Quadruple Bypass

January 28th, 2012, 15:35	#13
kbeckerton Trader rating Join Date: Sep 2011 Location: Sudbury, On	Can you Put a 9.6 nunchuck battery in the cheek rests? i just ordered this stock and a new battery so i hope i can lol..

January 28th, 2012, 16:24	#15
kbeckerton Trader rating Join Date: Sep 2011 Location: Sudbury, On	ah ook, well hopefully i dont screw it up lol

Magpul ACS STOCK REVIEW **56k death**

Reviews

Magpul ACS STOCK REVIEW 56k death