|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
March 8th, 2007, 12:22
|
#1 |
|
Barrel Wobble possible Solution?
I've been looking at the barrel on my m16 and was thingink about spot welding. Would it be a good idea to weld piece MA-16 to piece MA-17? The pieces are the one just after the receiver and the long straight section before the front sight.
|
|
|
|
March 8th, 2007, 12:47
|
#2 | |
|
no it wouldn't you can't weld the pot metal it will just spatter and not take a weld, use JB weld
__________________
JAYHAD: Commander - Airsoft Assassins distributing plastic death one nerd at a time JOC Age Verifier Quote:
|
|
|
|
|
|
March 8th, 2007, 13:04
|
#3 |
|
I just used those pipe clamps but now I use those LED mounts that clamp onto the barrel but i clamp it onto the inside. I used teflon tape first
__________________
YANHCHAN'S AIRSMITHING: AEG repair/Tune up/Upgrades V2/V3 mechboxes, rewiring/reconnecting. Ask not what your country can do for you; ask what you can do for your country ~John F. Kennedy |
|
|
|
|
March 8th, 2007, 13:47
|
#4 |
|
Rest in Peace
|
Better solutions are available in the Doc's section:
http://www.airsoftcanada.com/showthr...ghlight=wobble There are reasons why JB weld and and Epoxy are not the prefered solutions. It's cheaper than getting a one piece outer barrel and metal body and works very well.
__________________
"Good judgment comes from experience. Experience comes from bad judgment!" |
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
